How to provision ArborXR configuration packages on your VR devices

How to provision ArborXR configuration packages on your VR devices

This guide provides step-by-step instructions on how to provision ArborXR configuration packages with the Moth+Flame app to your VR devices using the ArborXR Device Setup App. You should follow this method when you need to configure multiple devices or apply specific settings, apps, or files across your VR fleet. This process simplifies the setup by using a pre-downloaded configuration package and can be used in environments that don't have access to wifi (so long as the configuration package is downloaded in advance).

Provision the Configuration Package to Devices

  1. Ensure the configuration package is downloaded to the PC being used to provision devices. If your device fleet was provisioned through us, it will already have USB  debugging enabled. For more information on enabling USB debugging and developer mode, see this collection of knowledge base articles.
  2. Tether devices to the PC via USB-C and accept any in-VR prompts if your device requires it.
  3. Download the Device Setup App. (If you're using a DOD computer, we will send this file to you via a shared drive)
    • Alternatively, if you don't have an ArborXR account, download and install the respective version below for your computer.
  4. Launch the Device Setup App then select Provision with Configuration Package.
  5. Select the configuration package from your system file browser.
    • 💡 After selecting the configuration package, it will take a few minutes for the Device Setup App to extract and read the contents of the package. During this time you will continue to see the log-in page.
  6. Once the configuration package has been extracted, select the checkbox for your device then click Set Up.


    • Related Articles

    • How to Re-Provision a Device

      Factory Reset the headset: Turn off your headset Hold down the power and volume (-) button simultaneously until the boot screen loads Use the volume buttons to highlight Factory Reset and press the power button Use the volume buttons to highlight Yes ...

    • How to Un-Install & Re-Install ArborXR + Update Moth+Flame VR app

      Is your device stuck within the ArborXR home environment (e.g. unable to connect to WiFi, are stuck in an endless loop of prompts, and are unable to exit ArborXR Home to update the system OS)? To avoid factory resetting the device, try the following ...

    • Clone a VR Headset to Update a Device Fleet without Wifi

      If a fleet of devices requires an update and the headsets do not have access to wifi, there are two ways to deploy module updates: 1. Use an MDM (ArborXR) configuration package 2. Use SideQuest to clone a VR headset - Prerequisites for using this ...

    • Moth+Flame VR App Release Announcement

      We are happy to announce that the latest version of our VR app, which has been renamed to Moth+Flame, is available! This update brings a range of improvements designed to enhance your learning experience on Meta Quest devices. Here’s what you can ...

    • Connect to Wifi Inside ArborXR's Home Environment

      To enable wifi while inside ArborXR's home environment, do the following: 1. Select the wifi symbol in the tray 2. Switch the toggle on next to the word "status." Confirm the wireless network connects. 3. Select the content button at the far left of ...